Things TO KNOW ABOUT FOUNTAIN PUMPS

Aus Salespoint

When replacing a fountain pump or choosing a new one, very first there are some key terms to maintain in thoughts:

"Head": This is the maximum vertical lift of the pump. For example, a 6' head means the pump is rated to pump water up to 6 feet high. Note, however, that at 6 feet the pump would be delivering extremely tiny water, with gallons per hour about zero. So if you need to pump, say, 200 gph at 72", you will probably want about a 300-600 gallon per hour pump to do the job.

"GPH" : Gallons per hour, usually rated at distinct heights

"GPM" : Gallons per minute, generally rated at different heights

"Pump Curve" : The quantity of water volume "curved" according to numerous heights. A 500 gallon per hour pump, for instance, may possibly pump 500 gallons per hour at " lift, 350 gallons per hour at 24" of lift, and so logo forth. When getting a pump for the first time or when seeking a replacement pump, it is crucial that you know how many gallons per hour you want to pump and at what height (head).

Water Volume The total volume that you will be pumping is controlled by a few variables. 1 aspect is the size of the pump, as covered above. But you also need to consider how wide your tubing will be. Tubing is measured in two techniques: inside diameter (i.d.) and outside diameter (o.d.). Extremely skinny i.d. tubing will significantly minimize water flow. A lot of clients are shocked when they uncover that, following hooking up their 500 gallon per hour pump to 1/2" inside diameter tubing, they are only voc filters getting what they take into account a trickle.

We had an engineer do some calculations for us to illustrate the dilemma. Using a 300 gph pump with 1/two" tubing is going to restrict your flow to 253 gallons per hour. By increasing the pump to 450 gallons per hour, but nevertheless utilizing 1/2" tubing, you will boost volume only slightly, to 264 gallons per hour! The lesson is this: When purchasing a pump, discover out what size of tubing is supposed to go with it. An additional issue is operating the tubing too far. Extended lengths of tubing produce resistance. If your pump calls for 1/two" i.d. tubing, for instance, but you are running the tubing twenty feet from the pump, it is

a good thought to use 3/four" tubing rather so as not to cut down also significantly on flow.

How much water do I require? What size of pump? This question is answered in component by whether or not you want a "trickle" or a roar. When you buy a fountain, you will usually discover a suggested flow. For waterfalls, use this as a rule of thumb: for each and every inch of stream width or waterfall "sheet," you will need to have to deliver 100 gallons per hour at the height you are pumping. So if you are constructing a 12" wide waterfall that is 3 feet tall, you need kangen water system talk to purchase a pump that will be pumping 1200 gallons per hour at three feet of height. For small ponds, whenever attainable, it is a very good idea to recirculate the water once

an hour, far more usually if feasible. Therefore, if your pond is 500 gallons, try to buy

a pump that will recirculate water at a rate of 500 gallons per hour. For actually

significant ponds, this is not essential and is far too pricey.